Nearby Community
Garage Door Service for Conway Homes
Serving Conway from Myrtle Beach, 13 miles out. We know the mid-90s builds here and the openers and springs that came with them.
- Licensed & Insured
- Same-Area Service Calls
- Upfront Pricing
How We Get to You
We run out of Myrtle Beach, about 13 miles from Conway, so we don't have a depot on this side of the county. What that means practically: we're not the crew that can be at your curb in ten minutes because we happened to be down the block. We schedule the drive into the job, and once we're on our way, we're on our way - no bouncing back to a shop for a part we should have brought the first time.
Conway is one of the farther stops in our coverage area compared to towns closer to the coast, and we're upfront about that instead of pretending otherwise. If you need someone who can be there in minutes because they're already parked two streets over, that's not us. If you need someone who shows up with the right torsion spring size and the right opener logic board for a house built in the mid-90s, that's the trip we're set up for.
What That Means for Doors
The typical house in Conway went up around 1994, which puts most of the doors and openers here in a specific window: early chain-drive and screw-drive openers, steel doors with the first generation of foam-core insulation, and torsion springs sized for the lighter, thinner panels that were standard before doors got heavier and better insulated in the 2000s. If your opener still has a manual code-setting dial with actual switches instead of a rolling-code button, that's a mid-90s tell, and it usually means the receiver board is getting close to end of life even if the motor itself still runs fine.
Springs on doors this age have usually been cycled tens of thousands of times already. A spring that's original to a 1994 build is not a spring anyone should be trusting through another winter. Track alignment on these older doors also drifts more than people expect, since the original hardware wasn't built to today's tolerances.
We see a lot of doors here that run but run rough - bent track, worn rollers, a cable starting to fray at the drum. None of that is an emergency until it is.
The Houses Here
Conway holds about 8,295 households, smaller than the broader service area's roughly 63,591, and median household income here runs around $54,841 - lower than the wider area's $67,618. That gap shows up in how people handle garage doors: fewer full-system replacements on a whim, more targeted repairs - a spring swap, a new set of rollers, a logic board instead of a whole opener.
We don't push replacement when a repair will hold. If your opener is original to the house and the motor's fine, we'd rather put in a new circuit board or a new receiver than sell you a unit you don't need. Where replacement does make sense is when the door itself - the panels, not just the hardware - has taken the kind of wear a 30-year-old steel door shows: rust at the bottom panel, delamination on the insulation, a frame that's racked from years of an out-of-balance spring pulling on it unevenly.
Climate here is mild with occasional freezes, not the deep-freeze conditions that crack seals and warp panels elsewhere, so the failures we see are age and cycle-count driven more than weather driven.
How Soon We Can Come Out
We don't have a crew stationed in Conway, so we can't promise a same-hour arrival the way we might for a town closer to Myrtle Beach. What we can tell you honestly: it's a real drive, roughly 13 miles each way, and we build that into how we route the day rather than squeezing you in as an afterthought.
If your spring has let go and the door won't move at all, tell us that when you call - a door stuck shut or stuck open gets prioritized differently than a door that's just noisy or slow. If it's a working door with a developing problem - a track that's slowly bending, an opener that strains before it lifts - that's a job we can schedule rather than rush.
One limitation worth saying plainly: if you need a part that's obsolete for a mid-90s opener and the manufacturer's stopped making it, we may need to source a compatible replacement rather than an exact match, and that can add a day or two versus a same-day fix. We'd rather tell you that up front than have you wait on a part that isn't coming.
Recent Work
Recent Work Near Conway
How We Can Help
Garage Door Repair
Springs, cables, tracks, rollers, and openers fixed by a tech who explains the problem before touching anything.
Learn more →
Garage Door Installation
New sectional doors sized and installed for the housing stock actually built in this area.
Learn more →
Garage Door Service
Tune-ups, lubrication, and safety checks that catch a small problem before it becomes a service call.
Learn more →What Happens When You Call
Call or Request a Quote
Tell us what the door is doing and roughly how old the house is - that alone points us toward the likely part before a truck leaves.
On-Site Diagnosis
A tech checks the spring, cables, tracks, and opener in person and tells you plainly what is actually wrong.
Straight Price, No Surprises
You get a number before any work starts. It covers parts and labor, nothing added after the fact.
Fixed the Same Visit
Most repairs are done in one trip. If a part needs sourcing, we tell you that upfront instead of guessing.
Frequently Asked Questions
Do you have a location in Conway?
No. We run out of Myrtle Beach and drive out to Conway, about 13 miles each way. We don't want to imply a local depot we don't have - every job here is a scheduled trip, not a drop-in.
Why does my opener look so different from newer ones I've seen?
Most Conway houses were built around 1994, and openers from that era often use manual dial code-setting instead of rolling codes, plus older logic boards. The mechanics still work, but replacement parts for that generation are getting harder to source.
Is my original spring still safe to use?
A torsion spring original to a house built around 1994 has almost certainly logged tens of thousands of cycles already. We'd check the coil gap and rust before saying it's fine, but at that age, replacement is usually the safer call, not the repair.
Do you push full door replacement often?
Not as a default. Median income in Conway runs lower than some of the coastal towns we cover, and most jobs we see here are targeted repairs - a spring, a board, a set of rollers - rather than full system swaps, unless the panels themselves are rusted or racked.
Get Started
Get Your Door Fixed in Conway
Call now for same-area service.